CALL US 0207 2929 140

Menu
Personal Trainer Blogs

PERSONAL TRAINER & FITNESS BLOGS

Banner Iamage Jeremy Boyd
4 MIN READ

Programming For Fat Loss

Written By

Jeremy Boyd

Category

Personal Training, Programming

Posted On

24 November 2014

Share Article

Whilst much is made of the ultimate requirement to consume fewer calories than you expend in regards to weight loss, how you train will determine in large part, where that weight comes from. The right training will help you retain muscle and burn fat, whereas the wrong training could actually cause you to burn valuable muscle and reduce your metabolism.

When programming for fat loss, the following are the main criteria for ensuring optimal results:

  1. Minimal to non-existent rest periods
  2. Sufficient loads to stimulate protein turnover and muscle retention
  3. Sufficient density to stimulate the metabolism
  4. Sufficient effort to stimulate cardiovascular adaptations
  5. Elevated growth hormone levels

So how do you achieve all of the above and are any of them mutually exclusive?

Minimal Rest Periods

The important thing to do here is distinguish between rest and recovery. Rest means inactivity, recovery does not. Whilst recovery can involve inactivity, when it comes to fat loss, active recovery is king. This may vary in nature from one person to another, i.e. walking around to step-ups to skipping. Regardless of the client, if the goal is fat-loss, then rest periods should almost never be any longer than 60 seconds (occasionally there are physiological or psychological reasons that warrant longer rest periods).

Sufficient Loads to Stimulate Protein Turnover and Muscle Retention

If strength isn’t pursued at best or maintained at worst, the body can cannibalise lean tissue to provide fuel. The easiest way to prevent this is to ensure that each muscle group is subjected to a load representing at least 70% of the 1 Rep Maximum (1RM) for a given exercise. This means that regardless of which exercise is chosen, at some point during a workout, at least one exercise should be performed with relatively heavy weights.

Sufficient Density to Stimulate the Metabolism

Manipulating, or more specifically escalating, density is one of the best ways of promoting fat-loss when programming.

Essentially, all that is required to escalate density is to complete a given amount of work in a progressively shorter and shorter time frame or complete a progressively greater amount of work in the same time frame.

A great example of this would be to perform the following:

  • 9 Deadlifts
  • 6 Bent Over Rows
  • 3 Power Cleans
  • 3 Military/Push Presses
  • 6 Reverse Lunges
  • 9 Back Squats

The goal would be to complete 1-2 rounds of the circuit in as short a time as possible with a weight equal to the 5RM for the weakest of either the Power Clean of the Military/Push press. Rest 30-60 seconds and then repeat a further 2-4 times. On each subsequent workout, the goal would be to complete the same amount of work in a shorter overall time. It’s important not too focus too much on individual sets as a measure of progress, as the times for these can sometimes be misleading.

Sufficient Effort to Stimulate Cardiovascular Adaptations

Possibly the easiest to monitor and evaluate, this is clearly evidenced by an increase in heart rate and respiration beyond comfortable.

Depending on the level of the individual this may be seen in a sudden drop in work rate or a sudden quickening of breath. The more trained an individual is, the more they are able to push themselves, whereas more sedentary people will get the same results at a much lower level of effort.

Elevated Growth Hormone Levels

Whilst this is something you’ll rarely, if ever, be able to measure, it’s actually quite easy to produce.

The body will increase its production of growth hormone in response to elevated levels of lactic acid. Therefore, exercise selection, sequencing and programming should include a bias towards this where possible.

Ultimately there are two main ways to elevate lactic acid production:

  • Train anaerobically
  • Increase concentric muscle activity

Whilst the shift into anaerobic status is often simply achieved by adjusting the intensity or speed of the activity, it is not necessarily suitable for everyone, particularly beginners.

For this reason, biasing concentric contractions may be a more effective option.

 

There are two ways of increasing concentric muscle activity, exercise tempo and exercise selection.

In regards to tempo, the typical recommendation is to focus on slowing the eccentric portion of an exercise with a tempos such as 3010, whereas taking longer on the concentric with a tempo such as 1030 could actually be more effective for fat-loss.

In terms of exercise selection, some exercises have inherently higher levels of concentric activity. The following are all examples of exercises that bias the concentric portion of the relevant movement:

  • Box Jumps
  • Sled Drags
  • Stair Climbing
  • Medicine Ball Throws
  • Rowing

The main thing to remember when seeking to elevate lactic acid levels is that past a certain point, people will usually begin to experience e some degree of nausea. For this reason alone, it’s probably wise to remain just below the tolerance threshold.

So are any of these mutually exclusive? In short, no. The workout detailed above would achieve all of the five criteria detailed here for an optimal fat loss workout. That said, it’s not the only way of doing it. The following are three of the most common ways to modify programmes:

  • If traditional supersets are a preference, reduce the rest periods each week to increase density
  • Use a concentric dominant exercise as the last exercise in a complex to boost lactic acid
  • Use a lower body concentric dominant activity such as stair climbing as active recovery during an upper body workout

Whichever option you choose, make sure that it’s just enough of a change to stimulate progress and avoid pushing too hard unnecessarily.


blog comments powered by Disqus



  • Written By

    Jeremy Boyd

    Category

    Personal Training, Programming

    Posted On

    5 June 2014

    With the growth of the Internet and the ever increasingly diverse amount of information, understanding how to program effectively for clients seems to be becoming more confusing rather than less. In fact, visit most commercial sites and you’ll find articles talking about the conjugate method and it’s value in strength training, post activation potentiation (PAP) and it’s importance for power development and the importance of rest periods specified to the nearest second to maintain metabolic stimulus.

  • Written By

    Richard Scrivener

    Category

    Personal Training, Programming

    Posted On

    20 May 2014

    The ‘metabolic rate’ is often cited as an important factor when it comes to energy expenditure; furthermore High Intensity Interval Training (HIIT) is reported to increase metabolic rate above that of other forms of training, such as steady state or longer, slower cardiovascular training.

  • Written By

    Jeremy Boyd

    Category

    Nutrition, Personal Training

    Posted On

    8 December 2014

    At the time of writing, one of the greatest divides in the field of nutrition is the debate over the calorific model for weight loss. But why?

  • Written By

    Tom Godwin

    Category

    Nutrition

    Posted On

    13 January 2014

    In this short article I am going to look at one of the key factors that has been attributed to the rise in levels of obesity… Obesogenic environments. If we first of all look at what an obesogenic environment is, “the phrase Obesogenic environment refers to an environment that promotes gaining weight and one that is not conducive to weight loss within the home or workplace” (Swinburn, et al., 1999).

  • Written By

    Tom Godwin

    Category

    Exercise Referral

    Posted On

    28 April 2016

    Arthritis is a condition that effects many clients in the UK and as a fitness professional there is a strong chance at some point during your career you will work with a client who may be suffering with arthritis. There are two types of arthritis that people can suffer with: Osteoarthritis this is where there is damage to the cartilage of a joint and is most commonly due to wear and tear. This is normally localised and common in hips and knees, or any joints that have seen excessive use. The condition will greatly effect movement and results in pain, leading to in many cases a loss in the level of functional ability. It is generally localised to the joints effected, and does not spread. This condition is brought on by obesity, repetitive movement patterns, impact through the joint, or trauma.

  • Written By

    Adam Willis

    Category

    Personal Training

    Posted On

    21 July 2016

    In the fast-paced and ever changing world of Sport where athlete’s live in the World of Wins, Loses, Kilos, Seconds and Centimetres the role of the Strength Coach has become a key component of every athlete’s sport preparation. It is nearly impossible in this day and age to look on social media and not see some freak athlete performing an outrageous feat of Strength or Power under the watchful eye of their coach. Whether programmed or done to boost followers, like sex, these videos sell! However you view it the position of Strength Coach is now sexy, not Eva Mendez sexy, put pretty close.